CyberData 011186 Operation Manual page 3

Revision Information
Revision 930796N, which corresponds to firmware version 11.3.0, was released on February 18,
2015, and has the following changes:
•
•
Browsers Supported
The following browsers have been tested against firmware version 11.3.0:
•
•
•
•
Operations Guide
Updates the following text in
• "This relay can be used to trigger low current devices like LED strobes and security camera
input signals as long as the load is not an inductive type and the relay is limited to a
maximum of 1 Amp @ 30 VDC. Inductive loads can cause excessive "hum" and can interfere
with or damage the unit's
Adds the following text to
• "When configuring with an inductive load, please use an intermediary relay with a High PIV
Ultrafast Switching Diode. We recommend using the CyberData Door Strike Intermediate
Relay Module (CD# 011269) (see Section 2.3.3.2, "Connecting the Door Strike Intermediate
Relay Module")."
Internet Explorer (version: 10)
Firefox (also called Mozilla Firefox) (version: 23.0.1 and 25.0)
Chrome (version: 29.0.1547.66 m)
Safari (version: 5.1.7)
Section 2.3.2, "Using the On-Board
electronics."
Section 2.3.3.1, "Devices Less than 1A at 30
930796N
Relay":
VDC":
CyberData Corporation