MUTOH Valuejet VJ-2638 Operation Manual page 306

Troubleshooting
(2) The media is crumpled during initialization
NOTE
• If the media is jammed or torn, remove it according to
No. Possible cause
1 Are you using the recommended media?
2 Is the loading position of the media correct?
3 Is the media loaded at an angle?
4 Are there any foreign materials such as torn
paper attached to Pressurizing roller?
5 Is the printer used in an environment other
than the one specified, such as near an air
conditioner?
6 Are you using creased, damaged, torn or
curled media?
(3) The wrong media size is set during initialization
No. Possible cause
1 Are you using the recommended media?
2 Is the media loaded at an angle?
3 When the media is set, does it curl upward?
4 Is the printer used in an environment other
than the one specified, such as near an air
conditioner?
5 Are you using media that has been printed on
already?
280
VJ-2638/1638/1638W OPERATION MANUAL
7.3 The media is jammed
Remedy
Use the recommended media.
Load the media correctly.
Set the media straight.
Clean Pressurizing roller.
Only use the printer in an environment that is
specified for use.
Replace the media.
Remedy
Use the recommended media.
Set the media straight.
Straighten the media or set a new media.
Only use the printer in an environment that is
specified for use.
Use a new media.
.
Reference
4.2.1 Media
type
3.4.2 Setting
Roll Media
3.4.2 Setting
Roll Media
6.2.2 Cleaning
the inside of the
printer
Installation
manual
4.2.2 Cautions
on handling media
Reference
4.2.1 Media
type
3.4.2 Setting
Roll Media
3.4.2 Setting
Roll Media
3.4.1 Loading
roll media
4.2.1 Media
type
7.1 Malfunctions and failures