MUTOH Valuejet VJ-2638 Operation Manual page 19

VJ-2638/1638/1638W OPERATION MANUAL
Do not spill waste fluid when replacing Flushing-box sponges.
If waste fluid comes into contact with Grid roller, it may damage its surface and affect media feeding.
When cleaning Ceaning wiper,
• Do not touch Cleaning wiper and Head cap unit.
Head cleaning may not be performed correctly because of oil from your hands.
• Make sure to use Cleaning stick to wipe Print head.
A wet Cleaning stick may cause Print head to clog.
• Do not reuse Cleaning stick.
The attached dust, etc may damage Print head.
When cleaning around Print head,
• Never touch the nozzles of Print head.
Doing so may damage Print head.
• Do not touch the tip of Cleaning stick.
Print head may be damaged because of oil from your hands.
• Never put water, etc on the tip of Cleaning stick.
Doing so may damage Print head.
• Do not reuse Cleaning stick.
The attached dust, etc may damage Print head.
Do not slant the printer, prop it against a wall or turn it upside down.
The ink inside the printer may leak.
Moreover, normal operation after shifting (to these positions) cannot be guaranteed.
Unpacking or moving this printer must be done by the following number of people.
• More than 4 people
Installing the dedicated stands on the printer must be done by the following number of people.
• More than 4 people
When taking the printer out of the container box, make sure to remove the vinyl, install Reinforcement for
transportation, and hold Reinforcement.
If lifting up the printer with the vinyl on, there is a possibility the printer can slip and drop, and be damaged.
When you do not use the printer for a long period, make sure to pull out the power plug from the power socket for
safety.
Make sure to connect an earth wire to the earth connection that meets the following standards.
• Earth terminal of power socket
• An earth wire with a copper plate which is buried at 650 mm or more in the ground.
Before operation, make sure to read the Material Safety Data Sheet (MSDS).
Pay attention to the following points when cutting roll media.
Mishandling Razor blade may cause a cut on your finger or hand.
• When you hold media, do not place your finger on Media cut groove.
• Move Razor blade slowly along Media cut groove.
Before cleaning the areas other than Wiper and circumference of Print head, be sure to turn OFF the power and
disconnect the power plug.
When moving the printer, make sure to maintain a horizontal position.
1.2 Important safety instructions
Safety instructions
19