Handlebar Grip - Arctic Cat 2016 90 Utility Service Manual

MD2105
MD2441
MD2106
9. Connect the handlebar switch assembly and brake
switch connectors.
YT218
20
MD2445
10. Install the handlebar bracket, the cover, and the seat.
11. On the Utility, install the front and rear racks.

Handlebar Grip

REMOVING
1. Using a compressed air nozzle and low pressure,
peel up the inner corner of the grip.
2. Apply air pressure while twisting the grip back and
forth until it slides off the handlebar.
MD2448
INSPECTING
1. Inspect the grip for wear, cuts, or cracks.
2. Inspect the grip for deterioration.
INSTALLING
 NOTE: Before installing a handlebar grip, use con-
tact spray or alcohol to clean the inside of the grip and
the handlebar of glue residue, oil, or any other con-
taminant.
1. Apply a liberal amount of Handlebar Grip Adhesive
to the inside of the grip.
2. Slide the grip onto the handlebar until it is fully
seated.
3. Wipe off any excess adhesive.