Arctic Cat 2016 90 Utility Service Manual page 40

YT028
2. Secure the gear position switch wire as shown; then
tighten the cap screw on the hold-down clip securely.
YT165A
3. Install the starter one-way clutch/gear assembly on
the crankshaft; then with a thrust washer on each side
of the starter countershaft gear, install the starter
countershaft gear/countershaft into the crankcase.
YT024B
4. Install the starter countershaft housing; then install
the starter one-way clutch cover. Tighten the cap
screws securely.
YT023A
5. Install the driven pulley/centrifugal clutch assembly
onto the transmission input shaft; then install the
centrifugal clutch housing and secure with a flange
nut (coated with red Loctite #271). Tighten to 40 ft-
lb.
YT147
6. Install the movable drive face, bushing, and speed
limiter spacer.
YT164
7. Place the V-belt over the driven pulley; then over the
bushing/spacer. Pinch the belt in the middle to draw
it down into the driven pulley approximately 1 inch.
39