Arctic Cat 2016 90 Utility Service Manual page 19

MD2405
7. Remove the cotter pins; then remove the two inner
tie rod ends from the steering post.
MD2136
8. Remove the cotter pin; then remove the steering post nut.
MD2417
9. Remove the front support bracket, steering post outer
bearing cap, and the steering post assembly. Account
for the two cap screws, the outer and inner bearing
caps, and the two-piece plastic bearing.
NOTE: The inner bearing cap and the two spacers

do not need to be removed.
18
YT234
CLEANING AND INSPECTING
1. Wash the tie rod ends in parts-cleaning solvent. Dry
with compressed air. Inspect the pivot area for wear.
Apply a low-temperature grease to the ends.
! WARNING
Always wear safety glasses when using compressed
air.
2. Inspect the tie rods for damaged threads or wear.
3. Inspect the tie rods for cracks or unusual bends.
4. Inspect all welded areas for cracks or deterioration.
5. Inspect the steering post and brackets for cracks,
bends, or wear.
6. Inspect the plastic bearing halves and bearing caps
for cracks or wear.
7. Inspect the handlebar tube for cracks, wear, or
unusual bends.
INSTALLING
1. Place the steering post into position. Tighten the
two cap screws on the front support bracket making
sure the two-piece plastic bearing and the inner and
outer bearing caps are in place. Tighten the cap
screws to 20 ft-lb.
YT234
2. Install the steering post nut and tighten to 51 ft-lb.
Install a new cotter pin.