Arctic Cat 2016 90 Utility Service Manual page 43

YT035
2. Loosen the shift detent plug (A) approximately eight
turns; then remove the cap screws securing the trans-
mission case cover. Note the location of two longer
cap screws (B).
YT036A
YT220A
3. Carefully remove the transmission case cover while
pressing in on the output driveshaft and shift shaft to
leave components in the transmission case. Account
for two alignment pins and gasket.
YT038
42
YT041A
NOTE: The driveshaft thrust washer may be stuck

to the cover. Make sure to install it on the driveshaft
and keep together for assembly.
Disassembling
 NOTE: For steps 4-8 refer to illustration YT041B.
4. Remove the output driveshaft (A); then remove the
shift fork shaft (G).
YT041B
5. Remove the main shaft (B) and shift fork together.
Account for the shift fork, a spacer, and a thrust
washer.
YT051