Arctic Cat 2016 90 Utility Service Manual page 56

CD600
3. Remove the float pin; then lift the float with needle
valve from the carburetor body.
CD603
4. Remove the pilot screw assembly. Account for a
spring and O-ring.
CD608
5. Remove the idle adjustment screw assembly.
Account for a spring.
CD610
6. Remove the jet holder; then remove the main jet
from the jet holder.
CD604
CD605
7. Remove the slow jet.
CD606
CLEANING AND INSPECTING
! WARNING
When drying components with compressed air, always
wear safety glasses.
CAUTION
DO NOT place any non-metallic components in parts-
cleaning solvent because damage or deterioration will
result.
1. Place all metallic components in a wire basket and
submerge in carburetor cleaner.
2. Soak for 30 minutes; then rinse with fresh parts-
cleaning solvent.
3. Wash all non-metallic components with soap and
water. Rinse thoroughly.
55