Preparation After Storage - Arctic Cat 2016 90 Utility Service Manual

6. Plug the hole in the exhaust system with a clean
cloth.
7. Apply light oil to the upper steering post bushing and
plungers of the shock absorbers.
8. Tighten all nuts, bolts, cap screws, and screws. Make
sure rivets holding components together are tight.
Replace all loose rivets. Care must be taken that all
calibrated nuts, cap screws, and bolts are tightened to
specifications.
9. Clean the ATV thoroughly.
10. Disconnect the battery cables (negative cable first);
then remove the battery, clean the battery posts and
cables, and store in a clean, dry area.
NOTE: For storage, use a battery maintainer or

make sure the battery is fully charged (see Battery
section in this manual).
11. Store the ATV indoors in a level position.
CAUTION
Avoid storing outside in direct sunlight and avoid using
a plastic cover as moisture will collect on the ATV caus-
ing rusting.

Preparation After Storage

Taking the ATV out of storage and correctly preparing it
will assure many miles and hours of trouble-free riding.
Arctic Cat recommends the following procedure to pre-
pare the ATV.
1. Clean the ATV thoroughly.
2. Clean the engine. Remove the cloth from the exhaust
system.
3. Check all control wires and cables for signs of wear
or fraying. Replace if necessary.
4. Change the transmission lubricant.
5. Charge the battery; then install.
6. Connect the battery cables making sure to connect
the positive cable first.
7. Check the entire brake system (cables, shoes, etc.),
all controls, and brakelight; adjust or replace if nec-
essary.
8. Check the tire pressure. Inflate to recommended
pressure as necessary.
9. Tighten all nuts, bolts, cap screws, and screws mak-
ing sure all calibrated nuts, cap screws, and bolts are
tightened to specifications.
10. Make sure the steering moves freely and does not
bind.
11. Check the spark plug. Clean or replace as necessary.
12. Check the air filter and the air filter housing. Clean
or replace as necessary.
5