Fingerprint Reader Board - HP ZBook Studio G5 Maintenance And Service Manual

Fingerprint reader board

Description
Fingerprint reader board (includes bracket)
Fingerprint reader board bracket
Fingerprint reader cable
Before removing the fingerprint reader board, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the bottom cover (see
5. Remove the battery (see
Remove the fingerprint reader board:
1. Disconnect the cable from the fingerprint reader board ZIF connector (1).
2. Remove the Phillips M2.0×2.5 screw (2) that secures the fingerprint reader bracket to the computer.
3. Lift the bracket off the fingerprint reader (3).
4. Remove the fingerprint reader from the computer (4).
Reverse this procedure to install the fingerprint reader board.
Bottom cover on page
Battery on page 35).
33).
Component replacement procedures
Spare part number
L28662-001
L28674-001 (Bracket Kit)
L28668-001 (Cable Kit)
49