Power Cable And Terminal Block With Integrated Suppressor; Lower Front Cross-Member; Upper Rear Cross-Member; Upper Front Cross-Member - Atag VA6111AF Manual

7.11 Power cable and terminal block with integrated suppressor

Proceed as follows to replace the power cable:
(a) Remove the cover from the terminal block (located in the rear section). To do so, use a tool to
release the two plastic tabs and slide the terminal block to the right.
(b) Loosen the screw on the cable clamp, detach the electrical connections and pull the power cable
free.
Proceed as follows to replace the suppressor:
(A) Remove the worktop (see 1.1), the plinth and the lower front panel (see 1.2) and the left-hand lateral
panel (see 1.4), then lever the anchor tab towards the centre of the appliance, and lift the
suppressor.
(B) Detach the electrical connections and remove the suppressor from the left.

7.12 Lower front cross-member

(a) Remove the worktop (see 1.1) the plinth and the lower front
panel (see 1.2) and both lateral panels (see 1.4).
(b) Remove the four screws which secure the cross-member in
position.

7.13 Upper rear cross-member

(a) Remove the worktop (see 1.1), the plinth (see 1.2) and both lateral panels (see 1.4).
(b) Remove the two upper screws which secure the cross-member to the tub.
(c) Detach the plastic clips which secure the
cross-member to the lateral sheet metal
reinforcement plates.
(d) Pull the cross-member upwards and away
from the rear uprights.

7.14 Upper front cross-member

(a) Remove the worktop (see 1.1), the plinth (see 1.2) and both lateral panels (see 1.4).
(b) Remove the four screws which secure the upper cross-member
frontally.
(c) From inside the tub, remove the four upper screws (see 7.4.d).
(d) Pull the upper cross-member upwards and away from the
lateral uprights.
Important: To replace the latch ferrule and/or the plate, which are
secured to the tub, simply remove the central screw.
SOI/TD - PR
(a)
24
(b) (b)
(b)
599 38 70-09