Table of Contents
Advertisement
6.5 Drain pump
(a) Remove any residual water from the sump by
suction so that it does not flow into the tub and the
pressure switch tubes, then lay the appliance on the
rear panel.
(b) First remove the plinth, the lower front panel (see
1.2) and the bottom panel (if featured) (see 1.3).
(c) Working from the front, use pliers to detach the sump hose from the corrugated drain hose; detach
the electrical connectors.
(d) Using a tool, such as a flat-head screwdriver, detach
the two anchor tabs on the body of the pump, one at
a time. Care should be taken to avoid damaging or
breaking the anchor tabs. Remove the pump from its
seat.
When replacing: Mount the sleeve correctly to the sump and
the drain tube. Check for leaks by performing a test cycle.
SOI/TD - PR
(d)
17
(c)
599 38 70-09
Advertisement
Table of Contents
