Water Fill Tank; Models Without Water Softener - Atag VA6111AF Manual

7.6 Water fill tank

(a) From inside the tub, unscrew the steam venting ring.
(b) Remove the worktop (see 1.1), the plinth and the lower front panel
(see 1.2) and the left-hand lateral panel (see 1.4). Detach the tube to
the fill solenoid.
(c) Detach the fill tank from the drying duct (if featured) (see 4.1).
(d) Pull the fill tank upwards, taking care not to damage the O-rings on
the couplings to the water softener (if featured) and the tub.
7.6.1

Models without water softener

(a) From inside the tub, unscrew the steam venting ring.
(b) Remove the worktop (see 1.1), the plinth and the lower front panel (see 1.2) and the left-hand lateral
panel (see 1.4). Detach the tube to the fill solenoid.
(c) Detach the fill tank from the drying duct (if featured) (see 4.1).
(d) Detach the fill tank from the sump assembly.
When replacing:
When replacing the water fill tank, position the condense draining hose correctly, if featured, in
the rear corner of the basement, as shown in the following pictures.
SOI/TD - PR
When replacing:
When replacing the water fill tank, lubricate the O-
rings and position them correctly on the "male"
part of the coupling.
(d)
20
(a)
599 38 70-09