Table of Contents
Advertisement
7.7 Washing motor
(a) Remove any residual water from the sump by suction so that it does not flow into the tub and the
pressure switch tubes when the appliance is laid on the rear panel.
(b) Remove the worktop (see 1.1), the plinth and the lower front panel (see 1.2), the bottom panel (see
1.3) and the anti-flooding device (see 6.1 ) (if featured) and the right-hand lateral panel (see 1.4).
(c) Lay the appliance on the rear panel.
(d) Detach the electrical connections to the start-up capacitor.
(e) Remove the hoses for the sump and the heating element.
(f) From below, detach the two rubber motor supports from the base.
(g) Slide the motor laterally (from the right).
(f )
When replacing:
When replacing the motor, reposition the hose clamps correctly and check for leaks.
SOI/TD - PR
21
(e)
(g)
599 38 70-09
Advertisement
Table of Contents
