Table of Contents
Advertisement
Access from the base
6
NB: Before laying the dishwasher on a side panel or on the rear panel remove the water
in the sump by suction, for example with a syringe, so as it does not reach the pressure
6.1 Anti-flooding device (if featured)
(a) Remove the bottom panel (if featured) (see 1.3).
(b) Lift up and release the anchor tab.
(c) To replace the microswitch, lever the tabs open and remove.
6.2 Adjustable rear foot (built-in versions only)
(a) Remove any residual water from the sump by suction
so that it does not flow into the tub and the pressure
switch tubes, then lay the appliance on the rear panel.
(b) Remove the regulation screw from the bottom panel
(see 1.3b).
(c) Using a tool, detach the foot support and slide away
from the base.
6.3 Sump assembly
(a) Remove any residual water from the sump by suction so that it does not flow into the tub and the
pressure switch tubes when the appliance is laid on the rear panel.
(b) Remove the plinth and the lower front panel (see 1.2).
(c) From inside the tub, remove the basket and the lower spray arm (see 3.3).
(d) Remove the central drain filter (see 3.1) and the large washing filter (see 3.2).
(e) Remove the two screws which secure the spray arm support column and remove the column.
(f) Remove the two screws which secure the tub to the sump.
(g) Remove the bottom panel (if featured) (see 1.3).
(h) Remove the anti-flooding device (if featured) (see 6.1)
SOI/TD - PR
switch tubes or the tub.
(e),(f )
15
(k)
599 38 70-09
(b)
Advertisement
Table of Contents
