Basic Settings; Top Up With Rinse Aid; Top Up With Salt - Atag VA2216MQ User Manual

WARNING!
Hard water leaves a white coating on dishes and inside the dishwasher. It is therefore important
that you select the right setting for the water softener! See Water hardness in the chapter Settings.
Never run the dishwasher with an empty salt compartment if the water supply has a water hardness
in excess of 5°dH (9°fH / 6°eH / 0.9 mmol/l).

2. Basic settings

The first time the dishwasher is switched on, it is important that you choose the right settings to
ensure good dishwashing results. See page 19.
Set up:
Rinse aid
Water hardness
TAB (All-in-one detergent)
3.

Top up with rinse aid

Lift up to open
Press to close
1. Open the rinse aid compartment lid.
2. Carefully top up with rinse aid to the level marked MAX.
3. Wipe up any splashes of rinse aid around the compartment.
4. Close the lid firmly.
When the rinse aid needs topping up, the symbol lights on the display.
4.

Top up with salt

1. Remove the salt compartment lid by turning it anticlockwise.
Before washing for the first time
Drying is faster and a better result is achieved
if you use rinse aid. You will also achieve a
better dishwashing result with clear and
spotless dishes.
Top up the rinse aid compartment with rinse
aid if you have selected Rinse aid 3:01 - 3:05.
For a water supply with a hardness above
5 °dH (9 °fH / 6 °eH / 0.9 mmol/l), fill with salt.
Add salt to the salt compartment if you have
selected Water hardness 4:01 - 4:09.
7