Table of Contents
Advertisement
STRUCTURAL CHARACTERISTICS
2
The appliance may be considered as consisting of three major assemblies:
The entire structure is enclosed by a series of removable parts such as the worktop, the door, two lateral
panels, the plinth and the lower front panel. Removal of these parts facilitates access to the internal
components from above, from the front, from the sides and from the base of the appliance.
2.1 Door area
Control panel assembly
External door
Internal door
Hinge
Hinge pin
Lower door seal
Door latch assembly
Integrated dispenser
Electronic board
2.2 Base area
Base
Removable bottom panel (if featured)
Adjustable feet
Foot brackets (free-standing versions)
Adjustable rear foot (central) (built-in and fully-integrated versions)
Main electronic board (if featured)
Anti-flooding device (if featured)
Wash pump capacitor
Integrated terminal block/power cable/suppressor
Washing motor
Tube-enclosed heating element
Drain pump
Drain pump non-return valve
Fill solenoid valve (if featured)
Regeneration solenoid valve (if featured)
Plinth
Counterweight (free-standing versions, if featured)
Water softening system (if featured)
Salt sensor (if featured)
Level pressure switch
Anti-overflow pressure switch
SOI/TD - PR
DOOR AREA - BASE AREA - TUB AREA
6
599 38 70-09
Advertisement
Table of Contents
