Table of Contents
Advertisement
Access from above
4
4.1 Drying duct/fan (if featured)
(a) Remove the worktop (see 1.1)
(b) Raise gently and detach the duct from the water fill tank,
taking care not to damage the sponge sealing element
between the tank and the duct.
(c) From inside the tub, detach the intake ring by pressing the four
hooks.
(d) Carefully lift the duct and remove it.
(e) Detach the connector to the fan.
(f) In order to inspect or replace the drive belt, detach the upper cover from the fan taking care not to
damage the plastic hooks.
Access from the front
5
5.1 Sliding guide for upper basket
(a) Remove the upper basket (see 3.4.a).
(b) Remove the rear arrest by releasing the anchor tab and
pulling upwards.
(c) Remove the guide from the supports.
5.2 Control panel assembly
(a) Remove the door, then remove the six self-tapping screws
which secure the control panel to the inner door.
(b) Supporting the control panel assembly, remove from the
inner door.
(c) Detach the electrical connections.
The following components (if featured) are fitted inside the control
panel and secured by screws or pressure-fitted:
Timer (electromechanical versions)/Power-Display board
Knob assembly
Door handle
Pushbutton array
Pilot lights
SOI/TD - PR
(b)
9
(c)
(f )
II
I
III
(a)
599 38 70-09
Advertisement
Table of Contents
