Table of Contents
Advertisement
ACCESSIBILITY
1
1.1 To access the components from above, first
remove the worktop:
(a) Remove the two screws from the rear section.
(b) Push the top forwards and release.
In case of Built-In dishwashers the worktop is a metal plate. It is
fixed by screws to the structure.
1.2 To access the components housed in the base from the front of the appliance:
(a) Plastic plinth in free-standing appliances: Remove the two front screws which secure the plinth in
position, pull the plinth forwards and release it from the side panels.
(b) Metal plinth in built-in appliances: Remove the two front screws which secure the plinth in position.
foot supports (free-standing versions):
(c) Remove the three screws and detach the foot bracket.
and the lower front panel:
(d) Remove the screws which secure it to the structure; turn and pull out from beneath the lower front
cross-member.
1.3 To access the components housed in the base from the lower section, remove
the bottom panel (if featured) as follows:
(a) Remove the inner filters (see 3.1 and 3.2).
(b) Remove any residual water from the sump by
suction, so that it does not flow into the tub and the
pressure switch tubes, then lay the appliance on its
rear panel.
(c) Unscrew and remove the regulation screw from the
rear foot (built-in versions only).
(d) Remove the screws which secure the bottom panel
to the base).
(e) Release the built-in retaining elements placed on
the right and rear side: and remove the bottom
panel by sliding to the right.
SOI/TD - PR
(a)
4
(b)
( c)
(d )
(c)
599 38 70-09
Advertisement
Table of Contents
