Level/Anti-Overflow Pressure Switches And Support - Atag VA6111AF Manual

7.8 Level/anti-overflow pressure switches and support

(a) Remove the worktop (see 1.1), the plinth, the lower front panel (see
1.2) and the right-hand lateral panel.
(b) From the side, detach the electrical and hydraulic connections from
the pressure switch to be replaced.
(c) Using a tool, carefully detach the pressure switch from the support
and slide it downwards.
(d) To remove the entire pressure switch support, first remove the right-
hand lateral panel (see 1.4).
(e) Remove the screw which secures the support for the pressure
switches to the upright.
(f) Using a tool, release the two plastic anchors from the upright and remove the support.
(g) If it is necessary to perform electrical tests on the pressure switches:
before replacing the switches, detach the hydraulic connections and
remove the support (see above), move the switch to the front for testing.
When replacing:
Reposition the pressure switches correctly on the support and re-fit the hydraulic
connections. Ensure that the rubber elements between the pressure switch and the
support are correctly inserted.
In some model of dishwasher, could be the following support. As seen previously the support is attached to
the stud by a screw and two plastics anchors.
SOI/TD - PR 22
(d),(e)
599 38 70-09