Latch Assembly; Integrated Dispenser; Main Electronic Board - Atag VA6111AF Manual

5.6 Latch assembly

(a) First, remove the control panel (see 5.2), then the two screws
which secure the latch assembly to the inner door.
(b) To remove the microswitch, lever the anchor tabs open and
extract the switch from its housing.
Important: To replace the latch ferrule and/or the plate: remove the cap which covers the hole and
remove the central screw.

5.7 Integrated dispenser

(a) First, remove the external door (see 5.3) and detach the electrical connections.
(b) Remove the six screws which secure the dispenser to the inner door.
(c) Press the lateral anchor tabs.
(d) Push the dispenser and remove from the interior.
5.8 Main electronic board (if featured)
(a) After removing the plinth and the lower front panel (see 1.2)
(b) By using a tool release the hook which secures the board housing to the plastic support fitted to the
base.
(c) Slide the board housing from its seat, open it and detach the electric connections.
SOI/TD - PR
(a)
(d)
(b)
12
(b)
(b)
(c)
599 38 70-09