Programmable Raster Height And Raster Expansion Speed - Symbol P 300STD Product Reference Manual

P 300STD/FZY/PRO Scanner Product Reference Guide

Programmable Raster Height And Raster Expansion Speed

Note: This parameter is available only on the P 300PRO.
This parameter allows you to select the laser pattern's height and rate of expansion, and is
only used when Programmable Raster or Always Raster is enabled. This parameter is
intended for very specific applications, and is usually not necessary.
Select the laser pattern's height and/or rate of expansion.
1. Scan the bar code for either
SPEED below.
2. To represent a two-digit value, scan two bar codes from the next page. Valid values
are between 01 and 15.
3. If you make an error, or wish to change your selection, scan CANCEL.
2-90
RASTER HEIGHT
Raster Height (Default 15)
Raster Expansion Speed (Default 11)
or RASTER EXPANSION