Advertisement
Wing Fences and Vortex generators
A set of wing fences and vortex
generators is supplied in your
kit and fitment is relatively easy. On each
wing there is one large wing fence (see
here in red) for the outboard of the
wing, and 3 smaller fences (seen here in
grey) to go further inboard. You will see
impressions on the wings where the
fences are positioned. Pay particular
attention to the angles they should be
set at. For the inboard fences each has a
slightly different inner profile depending
on its position along the leading edge.
Before gluing, identify which one goes in
which position. Tack each in place with
cyano and then apply a bead of hysol /
epoxy on each side to secure in place.
The joints can then be painted to finish.
Advertisement
