Advertisement
Turbine and Trust Tube
The turbine assembly can now be
installed in the fuselage as a complete
unit. Feed the pipe through the
rear half of the fuselage and position so
the bypass is centered on the bearers
and at the rear the outer
flange piece running at 45 degrees to
the tailpipe is just within the rear of the
fuselage. You will notice there are 4 pre
drilled holes in the ply pieces fitted to
the bypass. These holes can be
used to drill through to secure the
turbine assembly to the bearers. We
recommend using a 90 degree drill
attachment to achieve this easily. Drill
now 4 mm holes and use the M4 x 25
with washer and locknut as shown on
the picture.
Advertisement
