Advertisement
Turbine and Trust Tube
After the resin is cured the duct looks like
shown on the photo.
At this point the bypass can be
measured for trimming. See how to
mark and measure the area
to be cut. Trim outside of the cut lines
with a dremel or suitable rotary tool and
tidy with files as appropriate.
We then move on to fitting the turbine. It
is easiest to do this whilst the assembly is
outside the model
as the thrust pipe / bypass / turbine is
effectively a self contained unit. This
manual describes fitment
of the JetCat P180RX turbine however the
bypass and mounting rails will
accommodate a larger
case turbine such as the JetCat P200SX
without modification.
43mm
45mm
145mm
Advertisement
