Advertisement
Aileron and Flap
The flap surfaces are installed for you at
the factory
with beautiful scale hinging. What
remains is for you to
install the servo and linkage. CARF Models
recommend a 25kg torque digital for the
flap surfaces.
We have used a aluminium arm at 38mm
between
centers for the flap. Drill the servo arm at
38mm Ø3mm
and install the M3 Ballink with M3 x15
and locknut supplied. Install the servo
arm on the servo and install the servo in
the wing using 2.9 x 13mm sheet metal
screws.
Using the M3 x 150 mm threaded rod and
then screw on the supplied M3 Aluminum
Ball ink and the M2 screw with nut .
Install the pushrod open end through the
back of the wing and screw
in to the M3 Ballink on the servo arm.
Once happy with the flap throws tighten
the nut on the end of the
pushrod.
Servo Center
Flap Up
Flap Down
Advertisement
