Advertisement
Turbine and Trust Tube
The rear of the tail cone of the
turbine should be set at 45mm from
the rear edge of the bypass. Ensure
this measurement is carried out
carefully. Once you have this position
set, ensure
the turbine is central within the pipe
by observing through the rear end of
the pipe. Adjust as
necessary and drill the 4 mounting
holes Ø4.0mm and mount the turbine
with M4 x 20 and M4 T-nuts .
The setup has been designed to
position the seam of the
pipe at the very top. Once you
have fitted the pipe you
must check that it is square before
permanently attaching
the two pieces. Then mark and drill
the pipe through the
bypass Ø3mm, at 4 points equally
spaced around the pipe.
Secure with 4 x M3x15 lock nut
and washer .
Advertisement
