Advertisement
Canopy and Canopy Latch
Slide the spring 1 cm over the brass
tube. Make sure that the pin protrudes
the fuselage surface and securely locks
into the hole in the canopy frame.
Use the white plastic sleeve to guide
the steel wire. Cut the white tube
approx. 3 cm shorter than the steel
wire, make a loop into the steel wire,
(add an M3 nut in the loop) and place
the end in an accessible place inside
the fuselage. Then glue the guide tube
with 30 min epoxy on to the inner
surface of the fuselage.
Advertisement
