GeoVision GV-IP LPR Camera 5R User Manual page 68

To enable the Center V2 connection:
1. Activate Link: Enable the monitoring through Center V2.
2. Host Name or IP Address: Type the host name or IP address of Center V2.
3. Port Number: Match the port to Port 2 on Center V2. Or keep the default value 5551. For
details, see 8.1 Center V2.
4. User Name: Type a valid user name to log in to Center V2.
5. Password: Type a valid password to log in to Center V2.
6. Click Apply. The Connection Status should display "Connected" and connected time.
7. To establish connection to the second Center V2, click the Connection 2 tab and repeat
the above steps for setup.
You can also find on this Center V2 settings page:
 Cease motion detection messages from: Stops notifying Center V2 of motion detection.
 Enable schedule mode: Starts the monitoring through Center V2 based on the schedule
you set in the Select Schedule Time section.
[Select schedule time]
 Span 1- Span 3: Enable recording (upon motion events) at up to 3 different time frames
for a day, represented by Span 1 to Span 3.

Weekend: Enable recording (upon motion events) for both Saturday and Sunday or for
Sunday only.
60