Checking Enclosure Status In Pasm - Promise Technology SmartStor NS4300N Product Manual

SmartStor NS4300N Product Manual
Reported Event
Migration or Rebuilding
on array X paused at Y%.
Migration or Rebuilding
on array X resumed at
Y%.
Migration or Rebuilding
on array X completed.
Migration or Rebuilding
on array X aborted at Y%
Migration or Rebuilding
on array X aborted at Y%
because of error.
RAID status: "OFFLINE".
The NS4300N X volume
Y is offline.
RAID status: "CRITICAL".
The NS4300N X volume
Y is not functioning
correctly.
RAID X had some errors.
Formatting was aborted!

Checking Enclosure Status in PASM

To check Enclosure status:
1. Start PASM.
See "PASM in your Browser" on page 64.
Or see "PASM in SmartSYNC" on page 65.
2. In the Tree, click the + beside the System icon.
3. Click the System Information icon.
4. Click the Enclosure Information tab.
See Figure 5.
RAID Volume Migration or Rebuild was paused
temporarily by user action.
RAID Volume Migration or Rebuild was paused and
then resumed by user action.
RAID Volume Migration or Rebuild has finished.
Normal.
RAID Volume Migration or Rebuild was aborted
(stopped) by user action.
RAID Volume Migration or Rebuild has aborted
(stopped) because of an error. Check the disk drives.
See page 116. Check the RAID Volume. See
page 117.
Check the disk drives. See page 116. Replace the
failed drive. See page 117. Create a new RAID
Volume. See page 84.
Check the disk drives. See page 116. Replace the
failed drive. See page 117. The RAID Volume will
rebuild automatically.
Check the disk drives. See page 116. Replace the
failed drive. See page 117.
124
Corrective Action