Enclosure Command - Promise Technology VessJBOD 1000 Series Product Manual

VessJBOD 1000 Series Product Manual
To view the current settings:
At the cli> prompt, type cable and press Enter.
The system returns:
CN#1 Cable Length = 1 meter
CN#2 Cable Length = 1 meter
To set Expansion connector CN2 for a 3-meter cable:
At the cli> prompt, type cable -a mod -s "cn2=3" and press Enter.
The system returns:
Cable length of connector 2 is set to 3 meter

Enclosure Command

The Enclosure command:
• Enables you to reboot the VessJBOD enclosure (below)
• Displays information about the VessJBOD enclosure (page 27)
• Enables you to make enclosure settings (page 28)
Rebooting the Controller
You can reboot just the controller (I/O module). This action might be needed to
help with setting changes on the VessJBOD.
To reboot the only the controller:
1. Verify that no data I/O activity is in progress.
2. At the cli> prompt, type enclosure -a mod -s "reboot=1" and press Enter.
When the cli> prompt reappears, the controller has rebooted.
To reboot the entire JBOD expansion unit:
1. Verify that no data I/O activity is in progress.
2. Turn the power supply switch (switches) OFF.
3. Wait 10 seconds.
4. Turn the power supply switch (switches) ON.
See page 27, Figure 5.
A controller reboot does NOT meet the system restart
requirements for a firmware upgrade.
Caution
26