Inspire SCS-202 Assembly And Operation Manual page 21

Step 18
1 - Lower Cable
1 - M10 x 35 Hex Bolt
1 - M10 x 50 Hex Bolt
1 - M10 x 55 Hex Bolt (Blue Dot)
4 - M10 Flat Washers
2 - M10 Locknut
1 - 1/2" Step Spacer
1 - Plastic Ball
1 - "U" Bracket
1 - Spring Clip
1 - M6 x 20 Button Head Bolt
1 - M6 Flat Head Nut
M10 x 55 Hex Bolt (Blue Dot)
1/2" Step Spacer
Cable Column Mount Pulley
Step 18: Select a Lower Cable (with "U" Bracket). Lay it out assuring it is not kinked. Attach the "U"
Bracket to the Cable Anchor Plate upper center hole. Route the cable up through the Floating Pulley
Assembly with Guide Bushing, then down around the rear pulley position and into the Base Beam. Push
the cable forward through the Base Beam past the front pulley position. Route the cable out through
the smaller hole and up around the Lower Cable Column Mount Pulley, capturing the cable between the
pulley and the lower cable retainer tab only. Install the front and rear Pulleys assuring that the cable is
seated in their grooves. Route the cable up the Cable Column and between the Dual Pulleys on the
Cable Column Slider. To secure the Cable End, place one Plastic Ball onto the end of the cable. Next
slide the cable end into the slot of the Cable End "U" Bracket. Finally, attach the Spring Clip to the "U"
Bracket using the M6 x 20 Button Head Bolt and M6 Flat Head Nut. Slide the retainer "O" Ring tight
against the Plastic Ball to complete using:
One (M10 x 35 Hex Bolt)
One (M10 x 50 Hex Bolt)
One (M10 x 55 Bolt (Blue Dot)
Four (M10 Flat Washers)
Two (M10 Locknuts)
One (1/2" Step Spacer)
Wrench Tighten Now)
(
Front Pulley
Lower Cable inside tube
M10 x 50 Hex Bolt
M10 x 35 Hex Bolt
One (Plastic Ball)
One ("U" Bracket)
One (Spring Clip)
One (M6 x 20 Button Head Bolt)
One (M6 Flat Head Nut)
Page 18
Floating Pulley Assy.
with Guide Bushing
Lower Cable "U" Bracket
and Anchor Plate
Cable Anchor Plate