Inspire SCS-202 Assembly And Operation Manual page 16

Step 13
Selector Stem/Top Weight Assembly
Front of Weight Plate has recessed area for
Weight Plate Number Stickers
Weight Plate
Bottom of weight plate has three feet
Top Weight Pulley and M12 Jam Nut
Rubber Donuts
Weight Stack Risers
NOTE: Before beginning Step 13: If optional 200 lb. heavy stack is being assembled, eliminate the
Weight Stack Risers. This space will be taken up by 5 extra Weight Plates.
Step 13: Slide Weight Stack Risers down the Guide Rods and onto the Shroud Plates. Next, slide the
Rubber Donuts down the Guide Rods until sitting on the Weight Stack Risers. Slide each Weight
Plate down the Guide Rods until all 15 Weight Plates (20 Plates for heavy stack) are resting on
the Rubber Donuts. Be sure that all Weight Plates are facing toward front of the machine. Front
Of Weight Plate is indicated by recessed area for weight stack numbers. Next, slide Selector
Stem/Top Weight Assembly down the Guide Rods and onto Weight Stack.
Repeat with the second Weight Stack.
Attach the Top Weight Pulley Assemblies and Jam Nuts on the Selector Stems, verifying that bolts
are threaded completely into the Selector Stems with Locknuts on the Pulleys bolts facing towards
front of the gym using:
(Wrench Tighten Jam Nuts)
IMPORTANT! Top Weight Pulley Assemblies must be fully threaded into the Weight Stack
Selector Stems with the Jam Nuts tightened securely before use. Failure to do so may
cause the Pulley Assemblies to come loose from weights and can cause injury.
Shroud Plates
Page 13
Two (M12 Jam Nuts)