Inspire SCS-202 Assembly And Operation Manual page 19

Pulley #1
Step 16
1 - Upper Cable
1 - 3 ½" Dia. Pulley
1 - M10 x 70 Hex Bolt
2 - 1/2" Step Spacers
1 - M10 Locknut
Start Upper Cable here
Cable Column
Slider Assy.
Step 16: Select one of the Upper Cables. Position the Left Cable Column Slider Assembly at a comfortable
working height. Slide the retainer "O" Ring up the cable about 3 inches from the cable end for
installation (this allows the cables to feed through their routings easier). Remove one Jam Nut from
the cable bolt and insert the cable bolt, threaded end down, through the bracket on the Cable Column
Slider Assembly. Return the Jam Nut to the cable bolt (below the bracket) to secure it on the Left
Cable Column Slider Assembly. Continue feeding the cable up around Pulley #1, into and through the
Left Top Beam, going out at the rear. Make sure you route the cable to the correct side of all cable
guides and pins. Failure to route the cable properly will result in damage to the cable. Now route the
cable over Pulley #3 and down through the Floating Pulley with Guide Bushing, Pulley #4. Make sure
the Guide Bushing is facing towards the rear of the machine. Route the cable up over Pulley #5 and
Pulley #6 and down to the Weight Stack Top Pulley #7. Route the cable up over Pulleys #8 and #9
and then down through the second Floating Pulley #10. Complete the cable routing going up over
Pulley #11 at the rear of the Lat Attachment and forward out through the Swivel Pulley Assembly at
the front of the Lat Attachment. Attach Cable End by placing one Plastic Ball on the end of the cable,
next slide the end of the cable into the slot of the Cable "U" Bracket. Attach the Spring Clip to the "U"
Bracket using a M6 x 20 Button Head Bolt and M6 Flat Head Nut. Slide the retainer "O" Ring tight
against the Plastic Ball. Finally, install Pulley #2 in the Top Beam per above detail using:
One (M10 x 70 Hex Bolt)
Two (1/2" Step Spacers)
One (M10 Locknut)
(Wrench Tighten Now)
Pulley #2
Upper Cable inside Left Top
Upper Cable inside tube
Beam tube
Pulley #3
Floating Pulley Assy.
Floating Pulley Assy.
Pulley #10
Cable End Detail
1 - Plastic Ball
1 - "U" Bracket
1 - Spring Clip
1 - M6 x 20 Button Head Bolt
1 - M6 Flat Head Nut
Page 16
Pulleys #8 and #9
Pulleys #5 and #6
Pulley #4
Floating Pulley Assy. with
Guide Bushing
One (Plastic Ball)
One ("U" Bracket)
One (Spring Clip)
One (M6 x 20 Button Head Bolt)
One (M6 Flat Head Nut)
Cable End
Pulley #7