Inspire SCS-202 Assembly And Operation Manual page 15

Guide Rods
Shroud Mount Plates
Shroud Plate Spacers
Step 12
4 - M10 x 60 Hex Bolts, Blue Dot
4 - M10 x 95 Hex Bolts
12 - M10 Flat Washers
4 - M10 Locknuts
NOTE: The back side of the Shroud
Mount Plate has only one hole.
Step 12: Attach four Guide Rods to the Weight Stack
Mount using:
(Wrench Tighten Now)
Attach two Shroud Plate Spacers and two Shroud Mount
Plates to the Weight Stack Mount using:
NOTE: Be sure smooth flat side of plate is on top and
the single hole is to the back of the machine.
(Finger Tighten Only)
Weight Stack
Mount
Page 12
Four (M10 x 95 Hex Bolts)
Eight (M10 Flat Washers)
Four (M10 Locknuts)
Four (M10 x 60 Hex Bolts
with Blue Dot)
Four (M10 Flat Washers)