Inspire SCS-202 Assembly And Operation Manual page 18

Right Top Cable Column Mount
Step 15
4 - M10 x 60 Hex Bolts
8 - M10 Flat Washers
4 - M10 Locknuts
Left Cable Column Slider
Cable Column Tubes
Right Cable
Column Slider
Lower Right Cable Column Mount
Step 15: Identify one of the Cable Column Tube's upper end, (the
end with the slotted holes). Assemble the Right Cable
Column Slider onto the Cable Column Tube. Make sure the
Pop-pin aligns with the holes in the tube. Attach the Right
Cable Column Tube Assembly to the Right Upper and Lower
Cable Column Mounts using:
Repeat the procedure for the Left Cable Column Assembly
Using:
NOTE: Make sure all four bolts are installed from the front to the back as shown.
(Wrench Tighten All Previous Steps Now)
Left Top Cable Column Mount
Lower Left Cable Column Mount
Page 15
Two (M10 x 60 Hex Bolts)
Four (M10 Flat Washers)
Two (M10 Locknuts)
Two (M10 x 60 Hex Bolts)
Four (M10 Flat Washers)
Two (M10 Locknuts)