Inspire SCS-202 Assembly And Operation Manual page 12

Right Top Beam
Top Right Cable Column Mount
Step 7
2 - M10 x 100 Hex Bolts (Blue Dot)
2 - M10 x 110 Hex Bolts
6 - M10 Flat Washers
2 - M10 Locknuts
Step 8
2 - M10 x 100 Hex Bolts (Blue Dot)
2 - M10 x 110 Hex Bolts
6 - M10 Flat Washers
2 - M10 Locknuts
Step 9
1 - M12 x 25 Hex Bolt
1 - M10 x 45 Hex Bolt
2 - M10 Flat Washers
1 - M10 Locknut
Step7: Attach the Left Top Beam and Top Left Cable Column Mount
to the left Main Uprights AND the Right Top Beam and Top
Right Cable Column Mount to the Right Main Uprights using:
(Finger Tighten Only)
Step 8: Attach the Top Weight Stack Mount to the Rear Main
Uprights using:
(Finger Tighten Only)
Step 9: Install the M12 x 25 hex bolt in the top of the
Row Pulley Mount and adjust it to it's minimum height.
Attach the Top Weight Stack Mount to the Row Pulley
Mount with the M10 x 45 hex bolt. Insert this bolt from
front to go out the back, using:
(Wrench Tighten Steps 1 - 9)
Top Left Cable Column Mount
Page 9
Left Top Beam
Two (M10 x 100 Hex Bolts
with Blue Dot)
Two (M10 x 110 Hex Bolts)
Six (M10 Flat Washers)
Two (M10 Locknuts)
Two (M10 x 100 Hex Bolts
with Blue Dot)
Two (M10 x 110 Hex Bolts)
Six (M10 Flat Washers)
Two (M10 Locknuts)
One (M12 x 25 Hex Bolt)
One (M10 x 45 Hex Bolt)
Two (M10 Flat Washers)
One (M10 Locknuts)
Top Weight
Stack Mount