Figure 2-3 Vehicle Battery Cable Ends - Intermec 6820 User Manual

SECTION 2
Crimping the Cable Ends
Do the following to attach a terminal ring and a preas-
sembled in-line fuse link to the vehicle battery cable.
" NOTE:
You may have to shorten and restrip the red wire when attaching the
fuse link assembly.
1. Strip the black wire.
2. Crimp the 3/8" terminal ring (1) onto the black wire.
3. Locate the fuse link assembly (2) and attach it to the
4. Then, strip 1/4" (6 mm) of insulation off the red wire.
5. Crimp the red wire onto the fuse link (3).
Black (or Brown) Wire
4
Red Wire
red wire (shorten the red wire if desired).
1
Crimp
Here
1. 3/8" terminal ring
2. Fuse link assembly
3. Fuse link
4. Vehicle battery cable
Figure 2-3
Vehicle Battery Cable Ends
D Strip wire
D Install terminal ring
3
6820 Printer User's Guide
Installation
2
2-7