Direct-To-Battery Cable Installation; Figure 2-1 Two-Cable Installation Solution - Intermec 6820 User Manual

Installation

Direct-to-Battery Cable Installation

1. DC power cable — (4 feet or 1.2 meters — goes to printer)
2. Black (or brown) wire
3. 3/8" terminal ring
4. Fuse link assembly with 15-amp fuse
5. Splice
6. Vehicle battery cable — 8, 16, or 22 feet (2.4, 4.9, or 6.7 meters)
7. Chassis ground
We recommend you install printers directly to the battery
based on the following criteria:
"
"
2-4 6820 Printer User's Guide
Figure 2-1
Two-Cable Installation Solution
The vehicle battery acts as an electrical filter and reg-
ulator and supplies adequate power to the 6820 Print-
er mechanism.
If there is any damage to the printer dc power cable,
the cable is easily replaced.
SECTION 2