Figure 8-2 Removing And Replacing The Power Supply (Part 2 Of 2) - Sun Microsystems Ultra 60 Service Manual

Power cable
FIGURE 8-2
g. Slide the power supply toward the chassis front until the power supply rear
panel is flush with the chassis.
h. Using a number 2 Phillips-head screwdriver, tighten the captive screws
securing the power supply to the chassis.
Note – Tighten the captive screws in a clockwise order beginning with the upper
right captive screw.
2. Connect the AC power cord.
3. Detach the wrist strap.
4. Replace the side access cover.
See Section 7.3, "Replacing the Side Access Cover" on page 7-4.
5. Power on the system unit.
See Section 6.1, "Powering On the System Unit" on page 6-2.
8-4 Sun Ultra 60 Service Manual • August 2001
Removing and Replacing the Power Supply (Part 2 of 2)