Netware Setup - Sharp AR-P13 Service Manual

3.2.2

NetWare Setup

Start MAP and open the Setup NetWare page and setup the NetWare to make the printer operable in the NetWare environ-
ment.
1. Select the "Setup NetWare" from the "Network Configuration" menu screen.
2. Enter each field that applies:
Enable NetWare
Print Server Name
Print Server Password
Password Retype
Preferred File Server
Preferred NDS Context
Preferred NDS Tree
Print Queue Scan Rate
Ethernet Frame Type
Disable Bindery
3. Enter the password.
• The password is described as "∗".
4. Click on "Accept Setting".
• Click on "Clear Inputs" if you want to cancel the entered settings and re-enter them.
5. The entered settings are applied and the message "Update Successful" is displayed.
6. Power OFF the machine, then power ON again to restart the machine.
To use the printer under the operation of the NetWare server or the Peer-to-Peer Utility
(IPX/SPX), check it on.
Enter the name of the print server to be created. It must match the setting of the
NetWare. "SHA_XXXXXX" is set as default name. This is assigned for the port name
printed to when the Peer-to-Peer Utility (IPX/SPX) is used.
Please do not change the setting in general.
Please do not change the setting in general.
Enter the file server name preferred. It is available only in bindery mode.
Enter the NDS Context preferred. It is available only in NDS mode.
Enter the tree name of NDS preferred. It is available only in NDS mode.
Set the time interval for the print server to scan the print queues in the range of 1 to 255
seconds. It is set to 1 second as default setting.
Select a frame type you want to preferentially retrieve when more than one frame type
of NetWare are used. Usually, use the default setting.
Check it on only when using in the NDS mode of Netware 4.x. Check it off when using
NetWare 3.x or Netware 4.x in the bindery mode.
4-23