Manual Setting Of A Port; Uninstalling; Uninstalling The Peer-To-Peer Utility For Ipx/Spx; Uninstalling The Peer-To-Peer Utility For Tcp/Ip - Sharp AR-P13 Service Manual

4.3.2

Manual Setting of a Port

When the port is not automatically displayed even after the Peer-to-Peer utility for TCP/IP has been installed, perform the
following:
(1) Click on [Start], then select [Programs].
(2) Point [IP-P2P], then click on [IP-P2P].
• IP-Peer To Peer Setup starts.
(2) Start [IP-P2P](IP-PeerToPeer Setup) from the [Start] menu.
(3) Click on [Printers].
(4) Fill the field of each necessary item.
• [IP Address]
Input the IP address of the printer.
• [Name]
Input any printer name you desire. The port name will be the input here.
• [Port]
Usually, this does not need to be set. Input the value obtained by adding 1(one) to the "Peer To Peer Port No." at
the WebPage, "TCP/IP SETUP" in the Network SETUP of Administrator menu.
• [Description]
If necessary, input a comment for the printer.
(5) Click on [Add].
(6) The printer is added to the [Available Printers] list.
• If an addition has been made by mistake, click on the added printer then click on [Remove].
(7) Click on [OK] to close the [Printers] window.
(8) Click on [OK].
4.4

Uninstalling

If it is necessary to delete the Peer-to-Peer utility, perform the followings.
4.4.1

Uninstalling the Peer-to-peer Utility for IPX/SPX

Run the "Uninstal.exe" in the CD-ROM to uninstall.
4.4.2

Uninstalling the Peer-to-peer Utility for TCP/IP

Uninstall by performing [Add/Remove Programs] on the Control Panel.
NOTE:
Open the [Details] tab of the printer driver property, and make sure to change to "LPT1" for
[Print to the following port] before uninstalling the Peer-to-Peer Utility. Uninstalling may not be
completed correctly if the port is appointed at the port for the Peer-to-Peer utility.
4-30