Advertisement
Quick Links
[1] OUTLINE . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1
[2] SETUP . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1
PARTS GUIDE
Parts marked with "
" are important for maintaining the safety of the set. Be sure to replace these parts with
specified ones for maintaining the safety and performance of the set.
SERVICE MANUAL
CONTENTS
SHARP CORPORATION
CODE: 00ZARPX3//A1E
PRINTER I/F KIT
AR-PE2
AR-PX3
AR-PX4
MODEL
This document has been published to be used
for after sales service only.
The contents are subject to change without notice.
Advertisement
Related Manuals for Sharp AR-PE2
Summary of Contents for Sharp AR-PE2
- Page 1 SERVICE MANUAL CODE: 00ZARPX3//A1E PRINTER I/F KIT AR-PE2 AR-PX3 AR-PX4 MODEL CONTENTS [1] OUTLINE ..........1 [2] SETUP .
- Page 2 AR-PE2/PX3/PX4 Installation Manual 1) Remove the operation unit. FOR USE WITH COMPATIBLE SHARP COPIERS. SEE SHARP COPIER INSTALLATION MANUAL TO DETERMINE SUITABILITY. [1] OUTLINE This unit is used to connect the printer controller with the scanner and the printer section in the AR-C160.
- Page 3 5) Open the scanner (reading) unit and fix it with the hold shaft. 9) Attach the printer I/F card with the accessory screw, and connect the wake up signal harness and clock harness. 6) Remove the interface cabinet. Wake up signal harness 7) Remove the cover plate on rear cabinet.
- Page 4 3. Setting 1) Turn on the power of the unit. 2) Enter the simulation 26-1 mode. 3) Press "PRN: AR-PE2" button. (Communication between the unit and the printer controller is allowed.) 4) Cancel the simulation mode. 12) Connect controller side I/F cable and DC cable.
-
Page 5: Parts Guide
PARTS GUIDE 1 電源ﾕﾆｯﾄ (Power supply unit) PRICE RANK NEW JAPAN ONLY PART PARTS CODE DESCRIPTION ORDER CODE MARK RANK 1 XBPSD30P16000 ﾋﾞｽ Screw (3×16) 541 970 1103 RDENC0009FCZZ (100V Series) 電源基板 Power supply PWB 578 685 0519 RDENC0010FCZZ (200V Series) 電源基板 Power supply PWB 578 685 0520 3 DHAI-3325FC11... -
Page 8: Trademark Acknowledgments
All rights reserved. Printed. No part of this publication may be reproduced, stored in a retrieval system, or transmitted, in any form or by any means, electronic; mechanical; photocopying; recording or otherwise without prior written permission of the publisher. Trademark Acknowledgments Microsoft Windows, MS-DOS, Windows NT, Windows 2000 are trademarks of Microsoft Corporation in the U.