Netware 4.X Setup In Bindery Mode; Confirming Bindery Context; Setting Up Netware With Webpage Or Map - Sharp AR-P13 Service Manual

3.

NetWare 4.x Setup in Bindery Mode

The followings must be set up to use this machine as a network printer in the Netware 4.x bindery emulation mode network.
The printer server is set in the bindery mode when you want to preserve the environment of the existing Netware 3.x or also
allow clients of NetWare 3.x to use the print server.
• This machine
Select the "Network setup - Setup NetWare" menu in WebPage (URL for an administrator), and set up each item.
Or select the "Protocols - Setup NetWare" for MAP , and set up each item.
• NetWare server
Log in to the NetWare server with "Admin" from a client computer.
Use the "PCONSOLE" command, and add the print server.
* To set up in the bindery emulation mode, log in through the bindery connection. After logging in to the server,
press [F4] in console to switch to the bindery mode.
* Set up this machine in the print server mode. It cannot be set up in the remote server mode.
• Customizing the NetWare Server
Set up "Notify Options", as required.
SUPPLEMENTS:
• WebPage is an Web-based utility installed in this machine. This machine can be set up
by controlling the setup pages through the a WWW browser installed in the computer.
See "Chapter 4 Utility - WebPage" for further information.
• MAP is a utility that allows you to call and use a setting page via the IPX/SPX protocol.
See "Chapter 4 Utility - MAP" for further information.
• WebPage should be normally used to set up this machine. Use MAP in the network
where the TCP/IP protocol is not used, and if WebPage cannot be used. WebPage is
optimized for this machine.
3.1

Confirming Bindery Context

Before using the print server in the bindery mode, the bindery context must be stored in the NetWare 4.x server. Check if
the bindery context exists there. For the bindery mode, refer to the Operator's Manual for NetWare.
3.2

Setting up NetWare with WebPage or MAP

The following contents for NetWare 4.x must be setup:
When WebPage is used:
• Print Server Name
• Preferred File Server Name
• Bindery Mode
When MAP is used:
• Print Server Name
• Preferred File Server Name
• Disable Bindery
Set other items corresponding to requirements.
Enter the name of the print server to be created.
Enter the name of the file server to be logged in.
Be sure to Set "Enable".
Enter the name of the print server to be created.
Enter the name of the file server to be logged in.
Be sure to Set "OFF".
3-9