Sharp AR-P13 Service Manual page 87

1. Control Panel
Error Message
Displayed
Printer is under preparation Printer is being started
Printer error DMA Buffer Error
(Error code : P05)
Printer error Command Submit Error The command cannnot be submitted. Turn OFF the power of this machine and restart again.
(Error code : P09)
Printer error Detect Timeout
(Error code : P00)
Printer error Detect Timeout
(Error code : P50)
Printer error Fatal Error
(Error code : P56)
Printer error PCI Interface Error
(Error code : P55)
Printer error Print Server Card Error
(Error code : P54)
Printer error NvRAM Error
(Error code: P52)
Printer error Deficiency of Memory
sage (Error code: P51)
Printer error Expanded Memory
(Error code : P57) Error
F-ROM update error Fail F-ROM update
F-ROM update completed Complete F-ROM
F-ROM updating Start F-ROM update
Wait Warming up.
Add paper
Wait adding toner.
Close LCF Door.
Set correct cassette.
Remove paper from
duplexer.
Reboot the machine.
Invalid password.
Try again.
Error Type Description of Causes
The printer is under warm-up.
The necessary buffer cannot be
maintained when accessing DMA.
The system detects PCI timeout.
The printer detects PCI timeout.
The printer board detects a fatal
error.
The sequence PCI timeout error
occurs three times.
PRINT SERVER CARD error is
detected (only whenthe Print Server
Card is in use).
NvRAM error in the printer board
is detected.
Failed to maintain the memory while
rasterizing.
When an error occurs in the expanded H/W reset or replace the memory.
memory of the printer board.
Updating F-ROM has failed.
Updating F-ROM is completed.
Updating F-ROM has started.
Warm-up is underway.
When there is no paper on the
cassette.
When toner has run out.
When the door of the LCF is open.
Designated paper size and paper size Set the correct cassette.
in the cassette are different.
Paper is remaining in the Auto Duplex Remove paper from the Auto Duplex Unit.
Unit.
Wrong password.
Waiting to finish warm-up.
Turn OFF the power of this machine and restart
again.
H/W reset or turn OFF the power of this machine and
restart again.
H/W reset or turn OFF the power of this machine and
restart again.
H/W reset or turn OFF the power of this machine and
restart again.
H/W reset or turn OFF the power of this machine and
restart again.
H/W reset or turn OFF the power of this machine and
restart again.
H/W reset. All settings are revised to defaults except
IP Address.
The error is automatically cleared. LED and the mes-
is restored with H/W reset.
Retry the operation referring to "7. Update Firmware of
of Chapter 4".
H/W reset or turn OFF the power of this machine and
restart again.
—
It will be recovered automatically.
Add paper.
Add toner.
Close the door of Large-capacity Feeder.
Turn OFF the power of the machine and restart again.
Press the [CLEAR] button in the password screen of
the Control Panel.
5-1
Solution