Table of Contents
Advertisement
When Using Audio Devices
Connect the audio device to the AUDIO IN jack
with the XLR cable.
Set the AUDIO IN switch to [REAR] for the
channel to which the XLR cable is connected.
Set the LINE/MIC selector switch on the rear
panel to [LINE].
This can be set to detect when a connector is inserted into the
AUDIO IN terminal, and automatically switch between signals
input to CH1/CH2 and to CH3/CH4.
[REAR XLR AUTO CH1/2], [REAR XLR AUTO CH3/4] (page
189)
Mounting the Camera on a Tripod
When mounting the camera on a tripod, use the tripod adapter supplied with the camera.
Mount the tripod adapter on the tripod.
Tripod Adapter
Select an appropriate hole in the adapter, taking into
account the center of gravity of the camera and tripod
adapter combined.
Also, make sure that the diameter of the selected hole
matches the diameter of the pan head screw.
Mount the camera on the tripod adapter.
Slide the camera forward along the grooves until you
hear a "click".
Pan head
While holding the red lever down, move the black lever in the
direction of the arrow, and slide the camera backward to
remove it.
If the tripod adapter pin does not return to its original position
after the camera has been removed, hold the red lever down
and move the black lever in the direction of the arrow again, in
order to return the pin to its original position.
Please note that the camera cannot be mounted if the pin
remains in the center.
AUDIO IN
Switch
Removing the Camera from the Tripod Adapter
Tripod Adapter
Red Lever
Preparation: Mounting the Camera on a Tripod
LINE/MIC
Selector Switch
AUDIO IN Jack
Black Lever
Advertisement
Table of Contents
