Panasonic AJ-HPX3100G Operating Instructions Manual page 92

To format an SD memory card
SD memory cards may be formatted via the thumbnail screen.
[Formatting SD memory cards] (page 131).
Navigate the menu to the <SD CARD READ/
WRITE> screen.
Turn the JOG dial button to move the cursor to
the menu option CARD CONFIG.
Press the JOG dial button.
The following message is displayed.
To format the SD memory card, turn the JOG dial
button to move the cursor to YES. Then, press the
dial button.
When the SD memory card has been formatted, the
following message appears:
The card will not be formatted if the following message
appears when the JOG dial button is pressed:
Error message
CONFIG NG
NO CARD
(No SD memory card inserted.)
CONFIG NG
ERROR
(SD memory card cannot be
formatted.)
CONFIG NG
WRITE PROTECT
(SD memory card is write-
protected.)
CONFIG NG
CANNOT ACCCESS
(SD memory card not
accessible).
Adjustments and Settings for Recording Handling data
Remedy
Insert an SD memory card.
The card may be defective.
Replace the card.
Remove the card and cancel the
protect.
Example: The SD memory card
is not accessible because it is
being played back.
After the operation in process,
format the card.
To exit the menu, press the MENU button.
The settings menu disappears and the status of the unit
is indicated at the top and bottom of the viewfinder
screen.
Data erased by formatting cannot be restored, so be
sure to perform the format after first confirming the
data.
If an SD memory card is inserted or removed with the
<SD CARD READ/WRITE> screen open, the data title
cannot be edited.
Move the cursor to the option TITLE READ and press
the JOG dial button. Edit the data title.
To write set data on an SD memory card
Select the type of the menu to write to the <SD CARD R/W
SELECT> screen in advance, and then perform the writing
to the SD memory card via the following procedure.
Navigate the menu to the <SD CARD READ/
WRITE> screen.
To select a file number
Turn the JOG dial button to move the cursor to
the option W. SELECT. Then, press the dial
button.
Turn the JOG dial button to select a desired
number (1 - 8). Then, press the dial button.
To give the selected file a title
Turn the JOG dial button to move the cursor to
the option TITLE:.