Reconnection Of Incomplete Clips; Copying Clips - Panasonic AJ-HPX3100G Operating Instructions Manual

Reconnection of Incomplete Clips

Incomplete clips may be generated when clips recorded on
multiple P2 cards (connected clips) are separately copied to
different cards. Reconnection function generates one clip
(the original, connected clip) from incomplete clips.
Press the THUMBNAIL button.
The thumbnail screen appears on the LCD monitor.
Use the cursor and SET button to select
incomplete clips to reconnect.
marker) are displayed in line.
Press the THUMBNAIL MENU button and
select OPERATION
the thumbnail menu.
When a confirmation screen asks you to confirm that
you want to reconnect the clip, use a cursor button and
the SET button to select YES if you want to reconnect
the clip.
Clips that are connected as a group must be grouped together
or they will be displayed as incomplete clips.

Copying Clips

Selected clips can be copied to the P2 card or SD memory
card in the desired slot.
Press the THUMBNAIL button.
The thumbnail screen appears on the LCD monitor.
Use the cursor buttons to move the pointer to
the desired clip and press the SET button.
If recording using the one-clip REC function in which the clip
can be combined with the previous clip (when “1 CLIP” is
displayed), then copying of clips is not possible. Close the
menu, hold down the STOP button for 2 seconds to end this
connection, and try again.
RE-CONNECTION from
Manipulating Clips with Thumbnails: Thumbnail Manipulations Overview
Press the THUMBNAIL MENU button and
select OPERATION
thumbnail menu.
Select Slot 1-2 or SD memory card as the
destination.
When a confirmation screen asks you to confirm that
you want to copy the clip, use a cursor button and the
SET button to select YES if you want to copy the clip.
Do not turn off the power or remove a P2 card while data is
being copied. Doing so may cause the P2 card to fail. If you
should accidentally perform one of the above operations,
defective clips will be generated. Delete them, and then copy
them again.
When clips are copied to P2 cards, all the information on the
clips is copied. However, when they are copied to the SD
memory card *, video and sound information is not copied,
only thumbnails, clip metadata, icons, Voice Memo, proxy,
and real-time metadata.
When there is insufficient recording capacity on the
destination, the message “LACK OF REC CAPACITY!” is
displayed, and copying will not proceed. When clips to be
copied include some with defects, the message “CANNOT
ACCESS!” is displayed, and copying will not proceed. If
selected clips include any that are already recorded on the
destination P2 card, copying will not proceed.
To interrupt copying, press the SHIFT button + EXIT button,
or the SET button. Clips currently being copied to the
destination will be deleted.
When identical clips exist on the destination card, the
“OVERWRITE?” is displayed. Select “YES” or “NO”.
* Regarding SD memory cards to be used, see <Cautions
in using SD memory cards> (page 22).
COPY from the