Table of Contents
Advertisement
This function compiles multiple recordings into a combined
clip and does not isolate single recordings (from REC
START to STOP) to single clips.
REC Start
REC Start
First Recording
REC stop
Single Combined Clip
* Up to a maximum of 99 recordings can be combined into a
single clip. When the 99th recording ends, recordings are no
longer automatically combined into the same clip. Subsequent
recordings are combined into a new clip.
Use this function by setting the ONE CLIP REC MODE item
to “ON”. The menu item ONE CLIP REC MODE is found in
the <REC FUNCTION> screen on the SYSTEM SETTING
page.
When the ONE CLIP REC mode is selected, “1-CLIP” will
display in the lower right of the viewfinder and the LCD
monitor.
Start the first recording by pressing the REC button. “START
1 CLIP” will display.
Any subsequent recordings are automatically combined into
the clip. Up to a maximum of 99 clips can be combined into a
single clip.
Recording a New Clip
Follow the instructions below to use a new and separate clip
and end combining to the clip.
Press and hold the STOP button for about 2 seconds
while recording is paused. (operating while recording is on
standby)
Or
Press and hold the REC button for about 2 seconds while
recording to stop recording. (operating while recording)
Follow the instructions above to end combining to the clip.
“END 1-CLIP” displays. Subsequent recordings use a new
and separate clip.
In addition to the aforementioned steps, the following ends
combining to the clip and subsequent recordings use a new
clip.
When the power is turned off
When the P2 card with the previous recording is
removed
When the P2 card is formatted or the clip is deleted
(when the previous combined clip does not exist)
The clip does not stop combining even when the STOP
button is pressed in the Menu or on the thumbnail display.
Pressing the STOP button of the remote control unit (AJ-
RC10G) or the extension control unit (AG-EC4G) cannot quit
consolidating clips.
Recording and Playback: ONE CLIP REC Function
ONE CLIP REC Function
REC Start
Nth Recording*
REC stop
REC stop
Exiting ONE CLIP REC mode
Set the ONE CLIP REC MODE item to “OFF” in the Menu.
Cueing to the Start of the Combined Section of
the Clip
A text memo can be automatically added to the start of the
recording, the start of a section can be cued for playback,
and the thumbnail of the location can be checked before
each recording.
Automatically add a text memo to the start of the recording
by setting the START TEXT MEMO item to “ON”. The menu
item START TEXT MEMO is found in the <OPTION MODE>
screen on the SYSTEM SETTING page.
Check and playback the location of the added text memo by
selecting THUMBNAIL
TEXT MEMO CLIPS from the
Thumbnail Menu and moving the cursor over the desired
clip.
[Playing back a clip at the position where a text memo is
recorded] (page 124)
In addition, cue the location of the text memo for playback by
setting the SEEK SELECT item to “CLIP&T”. Press the FF or
REW button while playback is paused. The menu item SEEK
SELECT is found in the <OPTION MODE> screen on the
SYSTEM SETTING page.
Advertisement
Table of Contents
