Table of Contents
Advertisement
CANNOT ACCESS
CARD!
CANNOT ACCESS
TARGET!
CANNOT FORMAT!
CANNOT
RECOGNIZE
HDD!
CARD IS EMPTY!
CANNOT COPY!
FORMAT P2 CARD!
HDD
HDD CAPACITY
(USB HOST
FULL!
MODE)
HDD
DISCONNECTED!
MISMATCH
COMPONENT!
TOO MANY
PARTITIONS!
TOO MANY
TARGETS!
UNKNOWN DEVICE
CONNECTED!
VERIFICATION
FAILED!
An error occurred during P2 card access.
An error occurred during hard disk access.
The hard disk cannot be initialized.
The destination target cannot be properly
recognized.
The P2 selected for copying is empty.
This warning indicates that data could not be
imported from a hard disk to a P2 card
because the P2 card contained recorded data.
Not enough space left on the hard disk.
The unit is not connected to a hard disk.
Copying is not possible since the model
number of the destination card does not match
that of the source card.
There are too many partitions.
Multiple devices are connected.
The connected DVD drive is not compatible.
The compare check after copying failed.
Check P2 card.
Check hard disk status and connection.
Connect another hard disk drive.
Reboot the hard disk or connect a different hard
disk.
Copying is not performed since the card is empty.
You cannot copy to a P2 card that contains data.
Format the card on a P2 device and copy again.
There is not enough space on the connected hard
disk. Use a new hard disk or formatted hard disk.
Reconnect the USB cable. If the hard disk does not
operate normally, turn it off and turn it back on
again.
Use a P2 card with the same model number or
import video in clip units.
Hard disks can handle up to 23 partitions. Use a
new hard disk or formatted hard disk.
Disconnect devices, turn off the unit and turn it back
on again.
Disconnect devices, turn off the unit and turn it back
on again.
Copy the data again.
Maintenance and Inspections: Warning System
Advertisement
Table of Contents
